54
Chapter 3 Installation and Connection
HIGH FLOW INSUFFLATION UNIT UHI-4
Connecting the CLV-S190
1. Prepare the light source cable with remote (MAJ-1913 or MAJ-1953).
2. Connect the light source with the video system center using the light source
cable with remote as described in the instructions for the connectable light
source (CLV-S190).
3. Connect the plug of the light source cable with remote to the LINK-IN
terminal on the rear panel of the high flow insufflation unit. After connection,
secure each plug by pushing it in while turning the screws on both sides of
the plug (see Figure 3.14).
Figure 3.14
Video system center
(OTV-S190)
Light source terminal
Light source cable with remote
LINK-IN terminal
Light source
(CLV-S190)
OTV terminal
High flow
insufflation unit
(UHI-4)
To Next Page
Loading...
