Olympus UHI-4 - Connecting the Electrosurgical Unit (ESG-400, UES-40) or the Sonosurg Generator (USG-400, Sonosurg-G2)

Chapter 3 Installation and Connection
45
HIGH FLOW INSUFFLATION UNIT UHI-4
Insert the foot switch’s connector into the foot switch terminal on the rear panel
of the UHI-4 until it clicks as indicated by the arrow in Figure 3.8.
Figure 3.8
To disconnect the foot switch, hold the tip of the connector of the foot switch and
pull it straight.
3.6 Connecting the electrosurgical unit (ESG-400,
UES-40) or the SonoSurg generator (USG-400,
SonoSurg-G2)
This product, when combined with the electrosurgical unit (ESG-400, UES-40) or
the SonoSurg generator (USG-400, SonoSurg-G2) can exhaust fumes and mist
generated in the body cavity by synchronizing the ultrasonic or high-frequency
output and the exhaust function.
Never connect a cable other than the optional
communication cable to the high flow insufflation unit.
Otherwise, the high flow insufflation unit cannot perform
appropriately and injury or equipment damage may result.
• When using the automatic mist & smoke evacuation
system/function, also refer to the instruction manual for the
electrosurgical unit (ESG-400, UES-40) or the SonoSurg
generator (USG-400, SonoSurg-G2).
• To prevent malfunction, connect either the compatible
electrosurgical or compatible SonoSurg generator to the high
flow insufflator.