Olympus UHI-4 - Operating Steps

76
Chapter 5 Operation
HIGH FLOW INSUFFLATION UNIT UHI-4
When a filter is used with the device, connect the insufflation
tube to the UHI-4 as described in “Connecting an insufflation
tube (MAJ-590)” on page 59.
5.1 Operating steps
The following is the operation workflow. For details on each step, read the
corresponding description.
In addition to the operation described in the steps below, this instrument
incorporates the functions listed below. Please read the description before
performing any of the following functions.
• Relief mode (Function for automatic exhaustion of gas in the case of
excessive pressure)
Section 5.13, “Relief mode” on page 96
• Automatic suction (Function for auto suction of gas in the case of
excessive pressure)
Section 5.14, “Automatic suction function” on page 98.
• User mode (Function for modifying the settings of the instrument)
Section 5.15, “User mode” on page 100.
1. Turning the high flow insufflation unit ON.
 Refer to Section 5.2, “Power supply” on page 78.
2. Selecting the cavity mode from either “NORMAL” or “SMALL”.
 Refer to Section 5.3, “Selecting the cavity mode” on page 79.
3. Setting the cavity pressure.
 Refer to Section 5.4, “Setting the cavity pressure” on page 80.
4. Setting the CO
2
flow rate.
 Refer to Section 5.5, “Setting the flow rate” on page 81.
Next page