Olympus UHI-4 - Selecting the Display Mode

Chapter 5 Operation
83
HIGH FLOW INSUFFLATION UNIT UHI-4
5.7 Selecting the display mode
Areas that are not illuminated are disabled. To operate an
area that is not illuminated, press the display mode selector
switch to illuminate the area and then operate it.
Select the display mode using the display mode selector switch. The display
mode can be selected from three modes including “Convenient display mode 1”,
“Convenient display mode 2”, and “Complete display mode”. Each press of the
selector switch changes the modes in the cycle of “Convenient display mode 1”
→ “Convenient display mode 2” → “Complete display mode” → “Convenient
display mode 1”. The default mode set at the factory is the “Complete display
mode”.
The display mode can be selected from the following three
modes.
Display mode Note
Convenient display mode 1
The cavity mode indicator and the smoke evacuation
mode indicator are not illuminated, and other areas are
illuminated (see Figure 5.2).
Convenient display mode 2
The volume indicator, cavity mode indicator, smoke
evacuation mode indicator, and flow rate indicator
(except for the flow rate mode selection indicator) are
not illuminated. Other areas are illuminated (see Figure
5.3).
Complete display mode
All areas are illuminated (see Figure 5.4). The cavity
mode indicator is extinguished during gas feed.
Table 5.5