Omron 3G3MX2 Series - Page 41

3 Operation Procedure for Drive Programming
3 - 12
Drive Programming User’s Manual (I580-E2)
P114 Drive Programming
User Parameter U14
0 to 65,535 • These user parameters correspond to
the function variables U(00) to U(28).
• You can change the data by using the
Digital Operator. The changed data is
saved in the EEPROM.
• The set data will be saved in the
EEPROM when the Write to
EEPROM command is executed in
the Drive Programming.
P115 Drive Programming
User Parameter U15
P116 Drive Programming
User Parameter U16
P117 Drive Programming
User Parameter U17
P118 Drive Programming
User Parameter U18
P119 Drive Programming
User Parameter U19
P120 Drive Programming
User Parameter U20
P121 Drive Programming
User Parameter U21
P122 Drive Programming
User Parameter U22
P123 Drive Programming
User Parameter U23
P124 Drive Programming
User Parameter U24
P125 Drive Programming
User Parameter U25
P126 Drive Programming
User Parameter U26
P127 Drive Programming
User Parameter U27
P128 Drive Programming
User Parameter U28
P129 Drive Programming
User Parameter U29
P130 Drive Programming
User Parameter U30
P131 Drive Programming
User Parameter U31
Parameter
No.
Function name Data Description