Omron CJ - INSTRUCTIONS

3. Instructions
750
CS/CJ/NSJ Series Instructions Reference Manual (W474)
No.0 No.5
No.5 No.0
No.0
0.00
@CTBL
#0000
#0004
D0
TB D0
TB 1 D1
#0002
#03B6
#0000
#041A
#0000
#8000
#076C
#0000
#0834
#0000
TB 2 D2
TB 3 D3
TB 4 D4
TB 5 D5
TB 6 D6
TB 7 D7
TB 8 D8
TB 9 D9
#8005
TB 10 D10
High-speed counter 0
Registers a range comparison table with 1
to 32 ranges, and starts comparison.
First range comparison table word
Number of ranges: 2
Lower limit value 1
03B6 hex (950 decimal)
Upper limit value 1
041A hex (1,050 decimal)
Range 1 interrupt task No.: 0
(leaving range)
Lower limit value 2
076C hex (1,900 decimal)
Upper limit value 2
0834 hex (2,100 decimal)
Range 2 interrupt task No.: 5
(leaving range)
Note: Bit 15 = 1, so the interrupt task is executed
when the PV leaves the range.
High-speed counter PV
Upper limit value 2: 2,100 decimal
Lower limit value 2: 1900 decimal
Upper limit value 1: 1,050 decimal
Lower limit value 1: 950 decimal
Interrupt task that is started
Operating time
z Example for Range Comparison for 1 to 32 Ranges (CJ2M Only)
When CIO 0.00 turns ON in the following programming example, CTBL(882) registers a range comparison
table using upper and lower limits for high-speed counter 0 and starts comparison. When the PV of the
high-speed counter leaves the upper/lower limits for range 1, interrupt task 0 is executed. When the PV
leaves the upper/lower limits for range 2, interrupt task 5 is executed.