Omron CJ - INSTRUCTIONS User Manual

859
3. Instructions
CS/CJ/NSJ Series Instructions Reference Manual (W474)
Serial Communications Instructions
3
TXD
Programming Example
If CIO 0.01 turns ON while the RS-232C Port Send Ready Flag (A392.05) is ON, three bytes of data
starting from the upper byte of D10 are sent without conversion to the Code Reader connected to the
CPU Unit's built-in RS-232C port. These three bytes contain “@GO”, which is the normal read
command used as a trigger input to the Code Reader from the RS-232C line.
z Controlling Signals
4 E 00
4 0 35
15 8 71112 340
S: D10
@TXD
D10
D20
0.01 A392.05
S
C
&3N
RS-232C Port Send
Ready Flag
D11
@RXD
D100
D20
0.02 A392.06
A393
RS-232C Port Receive
Ready Flag
RS-232C Port
Reception Counter
Always #0.
Serial Port Specifier
#0: CPU Unit's built-in RS-232C port
0 0 00
15 8 71112 340
C: D20
RS and ER Signal Control
#0:
No RS and ER signal control.
Byte Order
#0:
Most significant bytes first
Three bytes
Lower byte
Upper byte
40 53 4E ED
Sent
@ G L
TXD
D300
D400
0.01
S
C
&0N
0 0 03
15 8 71112 340
C: D400
0
15
1314 12
S: D300
Turns OFF ER signal.
001
Turns ON RS signal.
Always #0.
Serial Port Specifier
#0: CPU Unit's built-in RS-232C port
RS and ER Signal Control
#3:
RS and ER signal control
Byte Order
#0:
Most significant bytes first
When CIO 0.01 turns ON, the
status of bit 15 of D300 is output
as the RS signal and the status
of bit 14 is output as the ER
signal.

Omron CJ - INSTRUCTIONS Specifications

General

Brand	Omron
Model	CJ - INSTRUCTIONS
Category	Controller
Language	English