380
PLC Comparison Charts Appendix A
Note 1. For CPU Units manufactured June 1, 2002 or later (lot numbers 020601@@@@ or later), up to eight
slot addresses can be set.
2. When a network with 8 levels is constructed, Routing tables must be set using CX-Integrator or CX-
Net in CX-Programmer version 4.0 or higher.
Online connections via networks with-
out creating I/O tables
With Automatic I/O Allocation
at Power ON: Yes (for all CPU
Units)
For Manual Operation
Pre-Ver.2.0 CPU Units: No
CPU Units Ver. 2.0 or later:
Ye s
Pre-Ver.2.0
CPU Units:
No
CPU Units
Ver. 2.0 or
later: Yes
No No Yes, but for
Controller
Link only
Sending FINS messages across net-
work levels
FINS messages can be used for remote pro-
gramming/monitoring over network layers.
Messages can be sent through different kinds
of networks.
Pre-Ver.2.0 CPU Units: Up to 3 network levels
CPU Units Ver. 2.0 or later:
Controller Link or Ethernet
(See note 2.): Up to 8 network
levels
Other networks: Up to 3 net-
work levels
No Yes, for 3 lev-
els
No
Online connections to PLCs via NS-
series PTs
Pre-Ver.2.0 CPU Units: No
CPU Units Ver. 2.0 or later: Yes
No No No
Protecting CPU Units from being written
by FINS commands sent via networks
Pre-Ver.2.0 CPU Units: No
CPU Units Ver. 2.0 or later: Yes
No No No
Downloading individual tasks Pre-Ver.2.0 CPU Units: No
CPU Units Ver. 2.0 or later: Yes
No No No
Read-protection
using passwords
Entire user program Pre-Ver.2.0 CPU Units: No
CPU Units Ver. 2.0 or later: Yes
No No No
Specified tasks Pre-Ver.2.0 CPU Units: No
CPU Units Ver. 2.0 or later: Yes
No No No
Enabling/disabling
creating file memory
program files
Pre-Ver.2.0 CPU Units: No
CPU Units Ver. 2.0 or later: Yes
No No No
Program write-pro-
tection
Pre-Ver.2.0 CPU Units: No
CPU Units Ver. 2.0 or later: Yes
No No No
Automatic transfer at power ON without
parameter file (.STD)
Pre-Ver.2.0 CPU Units: No
CPU Units Ver. 2.0 or later: Yes
No No No
Item CJ1-H/CJ1M Series CS1-H Series C200HX/HG/
HE
CVM1/CV
Series
CQM1H
CJ1-H-R CJ1-H CJ1-M
To Next Page
Loading...
