Omron E5CK

E5CK
5–31
C/F selection
Conditions of Use
The input type must be set to temperature
input (thermocouple or platinum resis-
tance thermometer).
Ă• This parameter can be used when thermocouple or platinum resistance thermometer
is selected as the input type.
Ă• Set the temperature input unit to either of C" or F".
Setting Range
Default
“”:C/“ ”:F
ĂRelated description
3.2 Setting Input Specifications (page 3Ć4)
ĂRelated parameter
Input type" (setup mode)
Parameter initialize
Ă• Returns parameter settings to their factory settings. However, note that the followĆ
ing parameters are not affected by execution of this parameter:
Input type", Scaling upper limit", Scaling lower limit", Decimal point" and
C/F selection"
Ă• When this parameter is selected, [
] (no") is first displayed. To initialize parameĆ
ters, press the
key to specify [ ] (yes").
Setup Mode
Function
Setting
See
Function
Example
of use