Maintenance Functions - 98
Load Portable Programmer
This function is used to transfer current data to the
Portable Programmer. The Portable Programmer (PP) is
then used to update the data in the stand-alone locks.
After 48 hours, the PP will erase this data as a security
precaution.
To load the PP with current data from the front desk
console, perform the following steps:
1. Connect the Portable Programmer and turn it on. See
Connecting to the on page 111 for instructions on
connecting the PP to the front desk console.
2. Enter your password and press the ENTER key.
3. Press the MENU key.
4. Press the RIGHT ARROW key six times to enter the
Communication menu.
5. Press the ENTER key to enter the Load P.
Programmer function. If the PP has current audit data
in its memory, a list of the doors audited will be
displayed. Refer to the section titled LOCKS AUDIT
TRAIL on page 80 for instructions on reading this
data. Once the data is read, press the CLR key to
clear the data.
Locks Audit Trail
101 11/24 17:56
102 11/24 19:41
6. The screen will prompt you to choose between
loading the complete data set for the locks or loading
the time data only. Load the complete data set if you
must Initialize or Update locks. Load only the time
data if you are simply adjusting the lock times or
wish to read the locks. Use the UP and DOWN
ARROW keys to select the proper option.
To Next Page
Loading...