Management / Security Functions - 61
8. Press the ENTER key. The screen will prompt you to
insert and remove the card. This will be repeated for
each copy of the card you requested.
9. The screen will return to the main menu. You may
select another function, or press the EXIT key to log
out of the system.
Blocking Card
This function is used to encode a Blocking Card. The
Blocking Card is used to take a room out of service for
an off season, or to seal a room after a criminal
incident. When a Blocking Card is used in a lock, no
other card will operate that lock, unless it has the
blocking override privilege. The lock is restored to
normal operation by using the Blocking Card a second
time in the lock.
To encode a Blocking Card, perform the following
steps:
1. Enter your password and press the ENTER key.
2. Press the MENU key.
3. Press the RIGHT ARROW key twice to enter the
Special Cards menu.
4. Press the DOWN ARROW key twice to select
Blocking Card.
Using a card with a new code
in a lock will void any
revious cards.
5. Press the ENTER key. The screen will prompt you to
decide if the code of the card should be changed, or
the existing code should be used. Press the ENTER
key to change to a new Blocking Card code, or press
the CLR key to remain on the same Blocking Card
code.
BLOCKING CARD
Change to a new code?
ENTER=Yes CLR=No
To Next Page
Loading...