Maintenance Functions - 114
NOTE: It is a good idea to use the Diagnosis Card
during this test. You will need a card anyway to
perform the card switch test and the Diagnosis Card
can be used for this purpose.
NOTE: The TEST function may also be used to indicate
why a card was rejected by the lock. Simply connect the
PP to the lock, select the TEST function, and insert the
card in the lock. The PP will display the reason the
card was rejected.
Initialize
The INITIALIZE function is generally used the first
time a lock is installed. It establishes the room number
for the lock and loads all the lock data. You should only
use this function if you have replaced a lock on a door.
To initialize a lock, follow these steps:
1. Connect the PP to the console and use the LOAD
PORTABLE PROGRAMMER function. See the
LOAD PORTABLE PROGRAMMER section on
page 100 in this manual.
2. Go to the lock and connect the PP.
3. Turn the PP ON and select INITIALIZE with the
MENU key.
4. Use the UP or DOWN arrow keys to select the room
number. Make certain to select the CORRECT room
number.
5. Press the green TX key.
6. Disconnect the PP when it is finished.
This lock is now initialized. Make a Guest Card for the
lock and test it. Also, be sure to test the Master Card(s).
To Next Page
Loading...