Onity HT22 - Using the HT22 System; System Setup and Connections

Using the HT22 System - 15
Using the HT22 System
Training Set Up
Connections
In order to begin the training, it is necessary to set up
the system components.
All external connections to the HT22 are made through
connectors on the rear panel. The power switch for the
unit is located on the rear panel, as shown in Figure 2
on page 18. To turn on the HT22, move the switch
toward the word “On” (toward the side of the unit). To
turn off the HT22, move the switch toward the word
“Off” (away from the side of the unit).