Using the HT22 System - 21
Press the MENU button, then press the Right Arrow
button six times until the Communications menu
appears.
Turn on the PP by pressing the Red ON/CLR button on
the PP.
On the encoder, Press the Enter button.
Press Enter at the next screen to accept the Complete
Loading default option.
Enter 1111 at the ‘PP Password’ prompt.
At the ‘From Room’ prompt, enter 9991 and press
Enter.
At the ‘Until Room’ prompt, enter 9991 and press
Enter.
If your system has been configured with ‘Back of
House’ locks, you will see the ‘From Door’ prompt. If
you see this prompt, press the CLR button on the HT22
Encoder and the HT22 will begin to load the
information into the Portable Programmer.
If your system has not been configured with ‘Back of
House’ locks, the HT22 will begin to load the
information into the Portable Programmer.
When the communication is finished, the HT22
Encoder will display ‘End of Comm’. Press Enter to
return to the menu. Press Exit to log out of the system.
The Programmer is now ready to Initialize the Sample
Mounted Lock. Plug the round connector from the
attached PP cable into the round jack in the bottom of
the lock.
Power on the PP by pressing the Red ON/CLR button.
Press the Menu button of the PP three times. You will
see ‘4. Initialize’ on the screen.
Press the UP arrow until you see ‘9991’ on the screen.
(This will be the only option unless your system has
been configured to work with HTCombo safes. In this
case, you will have ‘$9991’ as an option in addition to
‘9991’. Make sure to choose ‘9991’)
To Next Page
Loading...