29716AF 73
REMOTE SOFTWARE
SET UP A REMOTE CONNECTION
The administrator and up to nineteen additional users (four simultaneously) can access the
recorder remotely using software installed on a personal computer.
Configuring the Recorder
1. Press SETUP on the front of the recorder or remote control to log in.
2. Select NETWORK > NETWORK SETUP (see the Network Setup section of this manual
for more details).
3. Change port settings or write down current port settings.
4. Select DHCP or STATIC IP depending on your network (Ask your network administrator
for assistance).
5. If STATIC IP is selected - define the IP address and additional network information.
6. If DHCP is selected - write down the IP address supplied by the recorder system.
Note If the recorder does not display the IP Address after setting DHCP to ON, Select
SAVE to change the network and open Network Setup again.
7. Select SAVE to save current settings.
To Next Page
Loading...