29716AF 75
ACCESS REMOTE CONNECTION
1. Open the Remote Software.
2. Click on the icon of the server as defined previously.
3. Enter the user name and password of an authorized user as defined in the SYSTEM >
USER SETUP menu on the recorder.
Note User Name and Password are both case sensitive.
4. Click Connect.
Connecting Multiple DVRs
Connect up to four E240 or E480 recorders to the Remote Software to easily switch between
recorders.
1. Configure all recorder connections as described above in Configuring a Remote PC.
2. After connecting to the first recorder, click Connect on the Display screen to open the
Local Setup window.
3. Select a second pre-configured recorder and click Connect.
4. Use the drop-down menu in the lower left corner of the display screen to switch between
the connected recorders.
USING THE REMOTE SOFTWARE
Setting the Time and Date
The Remote Software uses the system time of the PC. If the system time is not correct, follow
the steps below to change it.
1. Exit to Windows by clicking the Exit button on the Live View screen and selecting
Restart in Windows Mode.
2. Open Windows Explorer. Do this by right-clicking the My Computer icon (located on the
top left hand corner of the Desktop) and select Explore.
3. Click Control Panel to open it. If you do not see Control Panel listed, click My
Computer to expand the folder tree.
4. Double-click Date and Time in Control Panel.
5. Adjust the Date and Time.
6. When finished, close all windows and restart the PC. Do this by clicking Start (located on
the lower left hand side of the Desktop) and selecting Shut Down.
To Next Page
Loading...