3-22 Installing and Operating the Tablet and Base Station E-Series
Battery Pack Warnings - Risk of fire, explosion, or burns
Do not reverse the positive (+) and negative (-) terminals.
Do not disassemble the battery pack.
Charge or discharge the battery pack only when installed in the Base Station.
Do not place the battery pack in temperatures exceeding 100°C (212°F). Examples
include direct sunlight or in a closed vehicle in hot weather.
Do not discard the battery pack in a fire.
Do not subject the battery pack to mechanical shock.
If the battery pack gives off an odor, generates heat, the case becomes discolored or
deformed, or in any way appears abnormal during use or storage, immediately
remove it from the Base Station and stop using it
.
Base Station E-Series Peripherals
The figure below shows the locations of the Integrated Customer Display Bracket, the
Wireless Scanner Dock, and the Integrated Mini Printer on the Base Station E-Series.
Figure 3-22 Base Station Peripheral Locations
Installing the Series 2 Pole Display Kit
The Series 2 LCD Pole Display Kit is compatible with the Base Station R-Series and E-
Series. The kit consists of an 18-inch pole and base, rubber spacer, LCD Customer
Display assembly, and the Extension Cable. After installation, test the display using the
Tablet Diagnostics in Section 4.
1. Use the base as a template to locate the mounting holes.
2. Install the rubber spacer on the LCD assembly cable so that it fits between the pole
bracket and pole.
3. After mounting the pole and base to the counter surface, route the extension cable
through the pole and connect it to the LCD assembly cable.
4. Attach the LCD assembly to the pole, position the head in the desired position, and
then lock in place with the supplied 1.5mm hex wrench.
To Next Page
Loading...
Need help?
General
