4-4 Tablet and Base Station E-Series Diagnostics Utilities
Other Devices
This test lets you evaluate the MICROS Integrated Mini Printer, the Base Station Scanner,
and an additional scanner such as the MSR/Imager/NFC-RFID module.
Printer Status
The Printer Status test is intended for the MICROS Integrated Mini Printer connected to
COM2 with 12V available.
The Printer Status consists of a group of ‘boxes’ each representing an electrical or
mechanical test of the printer.
To test the Mini Printer Status, make sure it is connected to COM2, loaded with paper,
and powered-up. Press the Start Monitoring button. All boxes should show Green.
With the Printer Status test running, open the Mini Printer door and observe the display.
Electrical and mechanical tests effected by the door being open will change to red.
Scanner
The Scanner test is used for the Base Station Wireless Scanner.
To use the scanner test, the Scanner and Dock must be paired correctly and the Wireless
Scanner Dock must be connected to an I/O Panel USB input.
With the Wireless Scanner and Dock connected to Base Station, tap the Start getting
Scanned Data button. Scan a UPC barcode and the bar code number appears in the
window along with a Carriage Return and Line Feed.
If the COM Port Error occurs when you tap the Start getting Scanned Data button, check
the USB interface cable to ensure it is connected to the I/O Panel.
NFC and NFC Command
These sections provide basic functional tests for optional NFC-RFID readers.
LEDs
This test lets you monitor and evaluate the Tablet Battery LED or Base Station System
LED by entering the Manufacturing Mode.
To begin, tap Start LED Test.
To Next Page
Loading...
Need help?
General
