OPTIMOD SURROUND PROCESSOR OPERATION
3-63
If your setting of a given DELTA RELEASE control would otherwise create a release
slower than “slow” or faster than “fast” (the two end-stops of the M
ULTIBAND
RELEASE control), the band in question will instead set its release time at the appro-
priate end-stop.
B1>LFE Couple
See Bass>LFE Couple on page 3-52.
B1-B5 Compression Ratio
: See page 3-53.
Note that the multiband gate only works appropriately when the K
NEE and RATIO
controls of all bands are set identically, which is typically the case in broadcast appli-
cations. We recommend turning off the multiband gate if the individual K
NEE and
R
ATI O settings are unequal.
B1-B5 Knee
: See page 3-53.
B1-B5 Breakpoint
: See page 3-53.
B1/B2 Crossover
(Band 1 to Band 2 Crossover Frequency) sets the crossover fre-
quency between bands 1 and 2 to either 100 Hz or 200 Hz. It significantly affects the
bass texture, and the best way to understand the differences between the two
crossover frequencies is to listen.
B1-B5 Main>Center Max +Delta GR; B1-B5 Main>Center Max –Delta GR
: See
Multiband starting on page 3-11 for an explanation of these controls.
To Next Page
Loading...
