Oriental motor BLE2D60-A - Connecting the USB Cable

Preparation
22
Safety precautions How to use Help Appendix
6. Connecting the USB cable
Connect the USB cable to the USB communication connector when
using the
MEXE02
.
USB communication connector
USB cable
Specications of USB cable
Specications USB2.0 (full speed)
Cable
Length: 3 m (9.8 ft.) or less
Shape: A to mini-B
Note
•
Connect the driver and PC directly using the USB cable without using a hub or extension cable.
•
In large electrically noisy environments, use the USB cable with a ferrite core or install a ferrite core to the USB cable.

Setting of ID
If the specic USB-ID (serial number) is assigned to the driver, the individual COM port number can be set in each axis.
When two or more drivers are connected to a PC at the same time, the individual COM port number can be set in each USB-ID.
When multiple drivers are connected with the USB cables at the same time, set the "USB-ID enable" parameter to "Enable," and
set the individual ID to each axis. To set the USB-ID, Windows automatically assign the specic COM port number in each ID.
Related parameters
ID Parameter name Description Setting range
Factory
setting
498 USB-ID enable
Sets whether to enable or disable the USB-ID.
When it is set to "Disable," the USB-ID is automatically set to a random number.
0: Disable
1: Enable
1
499 USB-ID
Sets the USB-ID (serial number).
The COM port at power-on can be xed.
0 to 999,999,999 0
2555 USB-PID Sets the ID to be displayed in the COM port. 0 to 31 0
Note
If the COM port number is changed, set the "Communication port setting" of the
MEXE02
again according to the COM
port number after being changed.