Oriental motor BLE2D60-A - Setting of Rotation Direction; Operating at Two or more Speeds (Multi-Speed Operation)

How to use
44
PreparationSafety precautions Help Appendix
5. Setting of rotation direction

Rotation direction of the motor output shaft
The rotation direction of the motor output shaft represents the direction when
viewed from the motor output shaft side.
The rotation direction can be changed with the parameter.
CCW
(REV input signal)
CW
(FWD input signal)
Related parameters
ID Parameter name Description Setting range
Factory
setting
450 Motor rotation direction
Sets the motor rotation direction.
(Sets the rotation direction when turning the FWD input ON if the “2-wire
mode” is selected with the “Operation input mode selection” parameter.
Sets the rotation direction when turning the CW/CCW input OFF if the
“3-wire mode” is selected.)
0: Positive direction=CCW
1: Positive direction=CW
1

Rotation direction when the local control operation is performed
During the local control operation, the rotation direction is continuously displayed blinking when the motor is at standstill.
At this time, the motor rotation direction can be changed by pressing key.
In the case of FWD:
(Factory setting)
Local control operation:
Using 3 keys of
, and ,
the motor can be operated.
In the case of REV:
6. Operating at two or more speeds (multi-speed operation)
The multi-speed operation can be performed by setting the rotation speed and switching the
ON-OFF status of the M0 to M3 inputs.
When the M0 to M3 inputs are assigned to CN5, the variable speed operation can be performed
using up to 16 operation data.
High speed
Low speed
Rotation direction of the gearhead output shaft
The rotation direction of the gearhead output shaft varies depending on the type or the gear ratio of the gearhead.
Check the operating manual of the motor for the rotation direction of the gearhead output shaft.