Oriental motor BLE2D60-A - Page 71

Help
71
How to usePreparationSafety precautions Appendix
The motor movement is not
stable.
Motor vibration is too large.
●
The motor and gearhead output shaft and a load shaft are out of alignment.
▷
Check the installation status of the motor (gearhead) output shaft and load shaft.
●
The product is aected by electrical noise.
▷
Check the operation using the motor, driver, and a minimum of external devices required to
operate.
If an eect of noise has been conrmed, implement the following countermeasures:
[Keep away from the noise sources.] [Reconsider the wiring.]
[Change the signal cable to a shielded cable.] [Install ferrite cores.]