OID Name Value Type Description
13.3002.2 Access view <Enum>
• none.
• basic
• extended
• all
Access view
options.
• none: Disable
SNMP v1 and v2.
• basic: Show
basic SNMP
information.
• extended: Show
extended SNMP
information.
• all: Show all the
SNMP inform-
ation
13.3002.3 Access mode <Enum>
• ro: Read only.
• rw: Read/write
Access mode
options.
13.3002.4 Source mask (1-5) <IP address> (i.e., 192.168.1.5 or 192.168.1.0/24) IP addresses from
hosts allowed to
retrieve inform-
ation from the
device using
SNMP v1 and v2
queries.
Note: In order to disable SNMP v1 and SNMP v2, the value none must be
chosen for access_view.
Note: Source mask value: By default, the localhost source is added. If no
other source mask is added the device will only accept local queries.
Caution: The default community name is public. For security reasons, it is
recommended to change this parameter.
Caution: Access mode configuration: For security reasons, it is not recom-
mended to provide read/write permissions while using SNMP v1 or v2.
3.
v3: Parameters for SNMP v3 users and passwords (see table below).
7.2 SNMP
CHAPTER 7 • WR-Z16 User Manual Rev. v3.4
101
To Next Page
Loading...