DANGER!
Installation of this product must be located in restricted access areas
where only skilled persons are authorized. This product is not to be
installed by the user/operator. Installation of the equipment must comply
with local and national electrical codes.
DANGER!
This equipment must be earth grounded. Never defeat the ground con-
nector or operate the equipment in the absence of a suitably installed earth
ground connection. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available.
Caution: To increase the lifetime of your device it is recommended to use it
in a controlled temperature environment and limit to the ambient con-
dition:
Temperature: -10°C ~ +50°C; Humidity; 0% ~ 90% RH
Note: The use of dust covers is recommended for the unused SFP/SFP+
slots.
2.6 Rack Installation
The device has been designed to be mounted in a standard 19-inch (48.3 cm) equipment
rack and thus respect the following physical dimensions:
Width: 431 mm
Height: 44mm (1x Rack Unit)
Depth: 300 mm
Caution:
The following guidelines are provided to prevent bodily-injury when mount-
ing or servicing this unit in a rack:
-This unit should be mounted at the bottom of the rack if it is the only unit
16
CHAPTER 2 • WR-Z16 User Manual Rev. v3.4
2.6 Rack Installation
To Next Page
Loading...