OID Name Value Type Description
13.3X10.1 User name <String> (i.e., userSNMP) Name of the
SNMPv3 user.
13.3X10.2 Access view <Enum>
• none.
• basic
• extended
• all
Access view
options.
• none: Disable
SNMP v1 and v2.
• basic: Show
basic SNMP
information.
• extended: Show
extended SNMP
information.
• all: Show all the
SNMP inform-
ation
13.3X10.3 Access mode <Enum>
• ro: Read only.
• rw: Read/write
Access mode
options.
13.3X10.4 Auth
<Enum>
• MD5
• SHA
Authentication
encryption pro-
tocol.
13.3X10.5 Priv
<Enum>
• DES
• AES
Privacy encryp-
tion protocol.
7.2.1.1 General configuration
In order to configure SNMP from the CLI, the wrz_config tool must be accessed. Once it
has been launched, the SNMP configuration is under Management > SNMP.
Figure 7-2: SNMP configuration.
Under the different tabs, all the described information in the previous tables or in the fol-
lowing sections can be accessed, modified, and saved.
On a different thread, the general commands to manage SNMP from a command line, e.g.
snmpget, snmpset, snmpwalk or snmpusm, are available in the device. A detailed explan-
ation about how to use them is out of the scope of this user guide, but multiple SNMP
102
CHAPTER 7 • WR-Z16 User Manual Rev. v3.4
7.2 SNMP
To Next Page
Loading...