Note: Matching device hardware: Orolias distributes different WRZ-OS
firmwares according to the hardware family of the device. The user must
follow indications provided in "Hardware version and firmware" below to
get the corresponding firmware before proceeding to its update.
Caution: The configuration is NOT compatible between major versions. If
the major version changes (for example from 2.X to 3.X or vice-versa), the
configuration on the device must be removed and configured again.
Caution: HW/SW compatability: For hardware versions higher or equal to
5.0, only software versions higher than 3.4 will be supported.
8.2.1 Hardware version and firmware
The HW version is displayed in the dashboard. The device shown below is a WR-Z16 that
mounts a Z16v4.0 as main board.
Figure 8-4: HW version displayed in dashboard.
The WR-Z16 can be updated using the firmware that matches the version of the main
board, or the new generic family firmware developed from the 3.4 software version:
wr-zynq-os-v<XXX>-<YYYMMDD>-Z16x.x_binaries.tar
wr-zynq-os-v<XXX>-<YYYMMDD>-Z164.x_binaries.tar
wr-zynq-os-v<XXX> -<YYYMMDD>-Z16_binaries.tar
But not the one that correspond to another device:
wr-zynq-os-v<XXX>-<YYYMMDD>-ZEN3.x_binaries.tar
Or the one that corresponds to another hardware version
wr-zynq-os-v<XXX>-<YYYMMDD>-Z162.x_binaries.tar
8.2.2 Using Web interface
Once the web GUI of the device has been properly opened (See "Connecting to the
Device" on page20), navigate to the Management > Firmware Update panel.
8.2 Firmware Update
CHAPTER 8 • WR-Z16 User Manual Rev. v3.4
127
To Next Page
Loading...