Note: If <DEVICE_ ID>.bin file is already present in your Download
folder, the newly generated file will be automatically renamed with a
suffix (i.e., <DEVICE_ID> (1).bin). Please remove this prefix before
uploading the file.
If everything works as expected, a <DEVICE_ID>.bin.confirmation should be gen-
erated back.
Return to Seven Solutions Flexera Portal.
Click on Devices > Offline Device Management.
Select the Generated License option and then select the previously downloaded
<DEVICE_ID>.bin.confirmation to Upload it.
Finally review if the license has been properly unlinked from your device. If it is the
case, this means that the corresponding purchased license can now be mapped
again to any other device.
8.1.5 License Server
It is not recommended to use local license management when running multiple (>10)
devices in the network. A license server can be setup in the management network so that
all the devices can directly request an active license to enable a feature. This solution has
the following advantages:
Only license server must synchronize to license portal in order to get all the pur-
chased license. This synchronization can be done online (seamless) or offline (using
a file).
Each device only needs to configure the License Server IP.
The license server is viewed as a poll of license that will distribute licenses to the
device only when they need them. This means that a license does not need to be
associated to a specific device (e.g., an offline/backup device will not consume any
licenses until it is connected to the network).
In order to get more information about this alternative, contact Orolia for assistance on the
solution that best fits the topology and help through its setup.
8.2 Firmware Update
There are two different ways to update the software and firmware of the device: through
the web interface or by using SSH/SCP.
126
CHAPTER 8 • WR-Z16 User Manual Rev. v3.4
8.2 Firmware Update
To Next Page
Loading...