Figure 8-9: Management panel in recovery mode
1.
Configuration: One of the first things to do when a device is in recovery mode is to
try to back-up its configuration, so it is easy to import it back or load it to another
device.
2.
Reboot: Then, try to reboot the device as the recovery mode has already per-
formed an automatic filesystem check and cleaning. If the device reboots in normal
mode, this means that the error in SD partition has been automatically fixed, oth-
erwise another recovery action might be executed.
3.
Firmware Update: Try to flash the firmware again (this is the most frequent action
to perform when an error has occurred during the flashing procedure).
4.
Restore: Remove any customization and restore the device to its default values
(WARNING: Any specific network settings will be removed).
If none of these actions can return the device to a normal booting mode, contact "Tech-
nical Support" on page141 to get more help.
8.3.1 Manual recovery mode
8.3.1.1 Using reset button
In case the recovery mode must be entered manually, the following steps need to be per-
formed:
8.3 Recovery Mode
CHAPTER 8 • WR-Z16 User Manual Rev. v3.4
131
To Next Page
Loading...