Figure 4-3: Time sources configuration in web interface
Finally, a settings menu on the upper right corner is shown. This menu allows to change the
password, enable the expert mode that includes additional parameters and log out from
the device:
The web session will automatically terminate after 15 minutes of inactivity. This setting can
be disabled or configured via the Expert mode in the Security section.
4.2.1 Network configuration from web
To illustrate how the user should interact with the web interface, an example of the con-
figuration of a static IP for eth0 network interface follows.
First, select the Network section from the left column, then select the tab ETH0 to con-
figure the corresponding interface (ETH0 is the default selection when entering the net-
work configuration).
Then in the CONFIG panel, the user must disable the DHCP option by clicking No in the
drop-down list box. If the DHCP is left enabled (Yes), the IPv4 fields will be blocked as read-
only, and the displayed values will be retrieved from DHCP responses.
34
CHAPTER 4 • WR-Z16 User Manual Rev. v3.4
4.2 The Web GUI
To Next Page
Loading...