Figure 4-4: Network interface panel in web GUI
Once DHCP is disabled (see below), the user will be able to edit the static IP settings to fit
its network configuration.
Figure 4-5: Configuration of static IP using web interface
Finally, the user can save the changes by clicking on Save button. After this action, a warn-
ing message will appear (shown in the following image), mentioning that the performed
changes will only have effect after the next reboot. This is because the parameters related
to network configuration have Load access instead of Write & Load access and thus can-
not be directly applied. The user can then directly execute a reboot (clicking on Reboot but-
ton) or continue to perform other configurations before rebooting.
Figure 4-6: Warning message to reboot the device so a saved change can take effect
4.2 The Web GUI
CHAPTER 4 • WR-Z16 User Manual Rev. v3.4
35
To Next Page
Loading...