Note: A license file will be generated using a <DEVICE_ID>.bin filename pat-
tern. Do not rename this file otherwise it will not be properly recognized
when loading it to the device. If a <DEVICE_ID>.bin file is already present in
your Download folder, the new generated file will be automatically renamed
with a prefix (i.e., <DEVICE_ID> (1).bin). Please remove this prefix before
uploading the file.
8.1.4.2 Create A New Device
First click on Create Device Button.
The fill the following parameters:
Name: unique device name on the network. It is recommended to use the
same name as the hostname.
Run Licenses Server: Disabled
ID Type: ETHERNET
ID: It corresponds to the eth0 physical address (MAC) of the device.
Note: The device ID format is based on the eth0 MAC address, but without
the doble- dot (:) and with only upper- case characters. It can also be
obtained from a terminal by executing:
gpa_ctrl hald net/eth0/ethaddr | sed 's/://g'
8.1.4.3 Load local license file in the device
In order to load the generated license file, the user first needs to access to the Man-
agement > Licenses > Configuration tab (Figure 8:4) within the web interface of the
device.
124
CHAPTER 8 • WR-Z16 User Manual Rev. v3.4
8.1 Licenses
To Next Page
Loading...