stopbits are : 1
escape is : C-a
local echo is : no
noinit is : no
noreset is : no
nolock is : no
send_cmd is : sz -vv
receive_cmd is : rz -vv -E
imap is :
omap is :
emap is : crcrlf,delbs,
Type [C-a] [C-h] to see available commands
Terminal ready
Note: USBdevice discovery
The target device's name may vary depending on the names of other
devices. The
dmesg | grep tt
y command can be used to discover which
name has been set to the connected device. This is an example output:
[4.616728] cp210x 3-6.1.2:1.0: cp210x converter detected
[4.620195] usb 3- 6.1.2: cp210x converter now attached to
ttyUSB0
In the case of the above output, /dev/ttyUSB0 would be the device’s
name.
As a recommended alternative,
Putty
for Linux works properly. Programs like
minicom
or
screen
can be used, although they are not fully recommended for color compatibility
issues.
3.2.4.2 Logging from SSH
Ubuntu distributions (and many others) have already installed all ssh-related tools neces-
sary to connect to the device. The user does not need to perform any specific steps and
can directly follow instructions detailed in "Logging from SSH" on page21.
3.2 Connecting to the Device
CHAPTER 3 • WR-Z16 User Manual Rev. v3.4
23
To Next Page
Loading...