Figure 3-2: Putty configuration for serial port connection.
3.2.5.2 Logging from SSH
It is also possible to connect to the device via SSH with Putty
The process to connect to the UART using Windows (XP, Vista, 7, 8, 10) is explained
below:
1.
Download and install the Putty Tool.
2.
Verify that the Connection type corresponds to SSH .
3.
Finally, write root@<IP> under the Host Name (or IP address) field, and click on
Open.
Compatibility with wrz_config
In order to make Putty compatible with the wrz_ config color scheme and avoid
strangecharacters, it is recommended to try the following configuration:
1.
Change remote character set to ISO-8859-1.
2.
Uncheck “Override with UTF-8 if locale says so”.
3.
Select “Use Unicode line drawing code points” (this is the default).
3.2.6 Logging from web
Once the device is set with an IP address, it can be accessed by typing http://<device_ip>
in the browser address bar. By default, https is disabled but if it has been enabled, the
address bar should be replaced by https://<device_ip>.
3.2 Connecting to the Device
CHAPTER 3 • WR-Z16 User Manual Rev. v3.4
25
To Next Page
Loading...