root@z16- 006:~# gpa_ ctrl hald /spll/ext/fpanel/detected
PPS & CLK
The expected output is PPS &CLK which means that both signals are detected.
9.2.2 Health general status
In order to check the device general status, there are multiple alternatives:
1.
SSH/UART
2.
Web interface
3.
SNMP queries
SSH / mini-USB UART
If you connect to the device via SSH/UART you will be able to check the WR-Z166 sync
status by typing:
gpa_ctrl healthingd
gpa_ctrl tmgrd vclock/info/
The WR-Z16 web interface
You can access the WR-Z16 graphical interface by setting the device an IP and copying its
address into the browser's URL bar.
General ports, mode and other configuration can be consulted or changed in the web.
SNMP.
This is the recommended alternative for monitoring purposes. Follow the steps on the
attached Monitoring Tools User Guide to get SNMP working.
You will be able to both consulting or changing configurations on the WR-Z16 with the
SNMP commands.
After having installed SNMP on your host, all parameters on the WR-Z16 can be checked
by typing:
$ snmpwalk -v2c -c public <WR-Z16 IP>
138 WR-Z16 User Manual
APPENDIX
To Next Page
Loading...