The corresponding firmware tar ball can be drag-n-dropped or Browse from the PC.
Then, press on Upload button and wait until checking the compatibility of the given
firmware. If the firmware is detected to be compatible it will automatically start the
upgrade procedure and reboot (twice) the device. Please wait in this screen until the
procedure complete.
Figure 8-5: Update Procedure Waiting screen.
If the uploaded version is lower than 3.4, a factory reset is mandatory. If this is the
case, the message in the following Figure will appear.
Figure 8-6: Downgrade warning on the GUI.
If an incompatibility (figure below) has been detected, the user should NOT con-
tinue with the flashing procedure except if the support team has confirmed that this
is the way to fix a specific problem.
128
CHAPTER 8 • WR-Z16 User Manual Rev. v3.4
8.2 Firmware Update
To Next Page
Loading...