OID Name Value Type Description
19.xx13.11 Transport
Mode
0. Multicast
1. Unicast
By default, multicast is used to automatically discover
the PTP peers. When unicast mode is selected, the
PTP topology must be pre-defined by filling unicast
destination.
19.xx13.12 Unicast Nego-
tiation
<Bool> Enable unicast negotiation support. This option is
needed by ITU-T G8265.1
19.xx13.13 Unicast Destin-
ation
<String> IPv4 address (or coma separated list of IPv4
addresses). Mandatory for slave unicast as they must
request to a predefined GM(s). Mandatory for GMs
with unicast negotiation disabled as they must
deliver to a pre-configured group of slaves.
19.xx13.56 Sync-E <Bool> Disable/Enable Sync-E operation mode
19.xx13.20 Announce Rate <Enums>
Default: 1 pack-
et/s
Rate of announce messages transmitted to be used
by BMCA/FOCA. From 1 packet each
[2,4,8,16,32,128] seconds to [1,2,4,8,16] packets per
second.
19.xx13.21 Sync Rate <Enums>
Default: 1 pack-
et/s
Rate of sync (and follow-up) messages from master
to slave (Figure
"Simplified PTP packets
exchange for delay measurement (1) End-to-
end (2) Peer-to-peer." on the facing page
).
From 1 packet each [2,4,8,16,32,128] seconds to
[1,2,4,8,16,32,61,128] packets per second.
19.xx13.22 Delay Req Rate <Enums>
Default: 1 pack-
et/s
Rate of delay request from slave to master. From 1
packet each [2,4,8,16,32,128] seconds to
[1,2,4,8,16,32,61,128] packets per second.
19.xx13.23 Peer Delayreq
Rate
<Enums>
Default: 1 pack-
et/s
Rate of Peer delay request when operating in P2P
mode. From 1 packet each [2,4,8,16,32,128] seconds
to [1,2,4,8,16,32,61,128] packets per second.
19.xx13.18 User offset <Integer>
Default: 0 ns
User offset to compensate internal PTP delay.
19.xx13.24 PTP Timescale <Enum>
1. PTP
2. ARB
By default the “PTP” timescale distribute the best
estimate of standard TAI timescale include the UTC
offset. If the user application does not need to be
“traceable” to UTC/TAI, the user can define its own
timescale and inform the network that timescale is
arbitrary (ARB),
9.xx12.x net/<iface>/server/cfg/ Configuration of the ESMCd daemon
9.xx12.1 Force SSM
Code
<Enum> -
Auto
QL PRC
QL SSU A
QL SSU B
QL SEC
QL DNU
SSM code provide by the ESMCd daemons. When
Auto the SSM code will be automatically selected
depending on the state of the device (i.e., QL PRC
when locked to external ref, QL DNU when free-run-
ning)
To Next Page
Loading...