The third panel of the HTTP/HTTPS menu allows to upload a certificate from your PC and
run HTTPS using that certificate.
Figure 6-3: Using HTTPS with uploaded certificate.
Caution: Once the secure mode has been activated, an info message will be
shown advising that the next connection will be done on HTTPS. After
rebooting the device, the HTTP port will be redirected to HTTPS. There is a
possibility to completely disable port 80, but be careful because if HTTPS is
not configured, the web access will be lost and the only way to enable it
again will be using CLI.
Finally, the fouth panel of the HTTP/HTTPS menu enables Diffie-Hellman parameters in
the TLS key exchange. This is optional but recommended. There are two buttons to gen-
erate and download the DH parameters file.
Caution: Diffie-Hellman generation time: To generate the Diffie-Hellman
parameters file, it is required to reboot the device and wait up to 20
minutes, or even more in some particular cases. In this period, the device
MUST NOT be powered off, rebooted or any similar action. The device will
not be accessible until this process finishes.
86
CHAPTER 6 • WR-Z16 User Manual Rev. v3.4
6.2 HTTPS
To Next Page
Loading...