Otodynamics Otoport Flex - Page 124

CHAPTER FIFTEEN
Conguration
124
Conguration
Norms
TE Norms are set and displayed in the same way that DP Norms are set.
Start
With start mode set to On (default), the testing will proceed from Checkt
to Test as soon as the Otoport detects a stable probe t, without the need
for the user to select Start.
With the Start setting O󰀨, the user must initiate the test by selecting Start
when the probe t and test conditions are satisfactory.
Irrespective of the Start setting, the Start button is available in order that
the user can initiate a test.
Stop
The Stop setting controls whether the test automatically stops when the
pass criteria are met. If Stop is turned O󰀨, the test will run for longer, but
the OAE levels will be more accurately measured. If Stop is On when
screening, the test will be as short as possible.