Oxford Technical Solutions Ltd Page 82 of 110
Accuracies tab
The NAVconfig software uses default accuracies for the measurements made during setup. These include
antenna positions, IMU orientation values and measurements for Advanced Slip settings. It is recommended
that you stick to these default measurements. However, if you wish to apply specific and more accurate values
for measurements then these can be edited in this Accuracies tab. Enter the values directly into the values
field.
Commands tab
Using the Commands tab you can enter device-specific commands that apply specific features or perform
actions onto the RT. The OxTS technical support team often use these and can provide you with a list of useful
commands if you request them at support@oxts.com.
The Write Configuration section of NAVconfig
Changes to the RT settings must be sent using Ethernet or Wi-Fi. It is necessary to configure your computer’s
LAN and WLAN settings, so it is on the same network as the RT.
Figure 43 shows the Write Configuration page.
To Next Page
Loading...