Oxford Technical Solutions Ltd Page 83 of 110
Figure 43: NAVconfig Write Configuration page
Enter the IP address of the RT you want to configure or select it from the dropdown list. The dropdown box will
list all systems currently connected to the computer’s network so ensure to select the correct system if there
are multiple listed.
Choose whether to commit the configuration changes immediately to the unit or save them until the next time
the unit is reset or power cycled.
Setting up the base station
For correct operation of the higher accuracy systems it is necessary to use a base station GNSS receiver. All of
the systems can be successfully used without a base station, however, the specification will only be met if a
base station is used.
The base station is a separate GNSS receiver that monitors signals from the GNSS satellites. Using its
knowledge of position it works out the errors in each satellite’s signal. It also measures the carrier-phase of
the signal for kinematic corrections. The carrier-phase observations and the satellite signal errors are sent
from the base station GNSS to the RT via a radio modem (not provided).
To Next Page
Loading...