56
Oxford Technical Solutions
Figure 17. NAVconfig Read Configuration page
Use default settings: NAVconfig loads the default settings the RT was delivered with.
Note: choosing Use default settings overwrites any advance settings that may have been
sent with prior configurations. To maintain those advanced settings, the Read initial
settings from device option must be used.
Read settings from a folder: It is possible to store a configuration in a folder. The
configuration comprises several files, so it is tidier to keep it in a folder by itself. To read
the configuration from a folder, select this option and then specify a folder by clicking
the Browse… button.
Read settings from an RD file: The RT writes the configuration it is using to the
internally stored RD file. This option extracts the configuration used and loads it into the
configuration wizard. Specify an RD file by clicking the Browse… button.
Read initial settings from device: If the RT is connected to the computer via Ethernet
it is possible to read the initial settings directly from the RT. The settings loaded are the
settings that were last committed to the RT using NAVconfig. Select this option and enter
the correct IP address of your RT, or select it from the drop-down list. The list will show
To Next Page
Loading...
Need help?
General
