95
The Advanced option is used to set special commands for the RT. This should only be
done with special instructions from OxTS.
Committing the configuration to the RT
Changes to the RT settings must be sent using Ethernet. It is necessary to configure your
computer’s Ethernet settings so it is on the same network as the RT. The section
“Ethernet configuration” on page 43 gives details on how to do this.
Figure 45 shows the Commit page.
Figure 45. NAVconfig Commit page
Enter the IP address of the RT you want to configure or select it from the drop-down list.
The drop-down box will list all systems currently connected to the computer’s network
so ensure to select the correct system if there are multiple listed. The list will not function
correctly if NAVdisplay or other software is using the RT UDP port unless the OxTS
UDP server is running.
To Next Page
Loading...
