55
Figure 16. NAVconfig Product Selection page
It is important to ensure the correct Product family, Product model and Product
generation is selected as the options and configuration pages shown in NAVconfig differ
between products. Any pages that are not available will be displayed as grey in the
sidebar.
The product model and generation can be found on the connector panel of your product.
If you only own one type of OxTS product, the Product Selection page can be skipped in
the future by clicking the Always use this product checkbox. If a different product needs
configuring, the selection page can be returned to by clicking Product Selection in the
sidebar.
Reading configuration
The Read Configuration page tells NAVconfig where to read the initial configuration
from (see Figure 17).
To Next Page
Loading...
