Chapter 11 Using Palm™ Photos
11 6
Beaming photos
The Beam command enables you to beam photos to other devices that are enabled
with infrared (IR) technology. The receiving device must have an application that
can display photos. For instructions on beaming a single photo, see “Beaming
data” in Chapter 3. Follow the steps below to beam multiple photos.
To beam photos:
1. Tap the Menu icon .
2. Select Photo, and then select Beam.
3. Tap the photos you want to beam.
A plus sign appears next to the photos you select.
4. Tap Beam.
5. Point the IR port on your handheld at the IR port on the receiving device.
See “Sending data” in Chapter 3 for additional information on beaming data.
Deleting photos
If you no longer want a photo on your handheld or expansion card, you can delete
the photo.
Ta p Be a m
To Next Page
Loading...
Need help?
General
