Chapter 16 Setting Preferences for Your Handheld
264
To create a login script:
1. Tap Script.
2. Tap the End pick list.
3. Select the command you want from the Command list. If the command requires
additional information, a field appears to the right of it for you to enter the
information. The following commands are available:
Wait For
Tells your handheld to wait for specific characters from the
TCP/IP server before executing the next command.
Wait For Prompt
Detects a challenge-response prompt coming from the server
and then displays the dynamically generated challenge
value. You then enter the challenge value into your token
card, which in turn generates a response value for you to
enter on your handheld. This command takes two arguments,
separated by a vertical bar (|) on the input line.
Send
Transmits specific characters to the TCP/IP server to which
you are connecting.
Send CR
Transmits a carriage return or line feed (LF) character to the
TCP/IP server to which you are connecting.
Send User ID
Transmits the user ID information entered in the User ID field
of the Network Preferences screen.
Send Password
Transmits the password entered in the Password field of the
Network Preferences screen. If you did not enter a password,
this command prompts you to enter one. The Password
command is usually followed by a Send CR command.
Delay
Tells your handheld to wait a specific number of seconds
before executing the next command in the login script.
Get IP
Reads an IP address and uses it as the IP address for your
handheld. This command is used with SLIP connections.
Ta p h e r e
To Next Page
Loading...
Need help?
General
