Panasonic BL-C210 Series

Therefore, in this example, the camera was triggered on June 18, 2009, at 5:30 PM and 20 seconds
and 500 milliseconds. Note that if you configure the camera to adjust its time setting for Daylight
Saving Time/Summer Time (see Page 140), an “s” will be inserted between the date and time of
the time stamp.
f. Enter the text
*2
that will be displayed in the body of E-mail messages sent by the camera (max. 63
characters).
• Line breaks cannot be entered.
2. Under [How to authenticate], select the authentication method your ISP requires for sending E-mail, and
enter the appropriate settings if necessary.
– [No authentication]: Select this option if the outgoing E-mail server does not require authentication
when sending E-mail messages.
– [POP before SMTP authentication]: Select this option if the outgoing E-mail server requires POP before
SMTP authentication when sending E-mail messages. The following settings are also necessary. Enter
the settings as you would for receiving E-mail.
a. Enter the IP address or the host name
*1
of the POP3 server (incoming mail server).
• An IPv6 address can be specified; note that the IPv6 address must be enclosed in brackets.
b. Enter the port number used by the server. (Port 110 is normally used for POP3.)
c. Enter the login ID
*2
(user name) required to access the server (max. 63 characters).
d. Enter the password
*2
required to access the server (max. 63 characters).
70 Operating Instructions
2.5.1 Sending Trigger Notifications by E-mail