Optional Controller
Manual of Controller
2 - 6
1. Timer Remote Controller (CZ-RTC4)
8
(EN)
Note
If the heating performance is insuf cient in Low fan speed, change the fan
speed to Medium
or High .
The temperature range that can be set varies depending on the model.
Temperature sensor detects temperature in the vicinity of the air inlet of the
indoor unit. The detected temperature slightly differs from the room temperature
depending on the installation condition. The set temperature is a guideline of
room temperature.
9
(EN)
1
Press and hold [SET] for more than
2 seconds to enter the present day
and time setting mode.
Once you enter the setting mode,
“SETTING”, “▼”(day) and “time” ash.
2
Set “▼” to today’s day of the week.
Press [
▲
] to move “
▼
” ( ashing on the
display) in the order of: Su → Mo → Tu → ....
Press [▼] to move it in the order of: Su →
Sa → Fr → ....
Press [SET] to store.
3
Press [▼/▲] to change the present
“hour” in the range of 0 to 23*
1
.
Set the present hour and press [SET].
The “hour” digits light up, and the “minute”
digits start ashing.
*
1
If the clock uses the 12 hours AM/PM
setting, the hour is displayed in the range of
AM 1 to 12 / PM 1 to 12.
4
Press [▼/▲] to change the present
“minute” in the range of 0 to 59.
Set the present minute and press [SET]. The
day and time are set and the unit nishes
the setting mode.
A
2 / 3 / 4 1 / 3 / 4
Note
If the present time is invalid, “– – : – –” is displayed. If the power failure occurs,
check if the set data of day and time are valid.
Setting the Present Time
Basic Operations
SM830241-00_2WAY SYS.indb 6 2015/03/26 14:54:52
To Next Page
Loading...
Need help?
General
