Optional Controller
Manual of Controller
2 - 32
2. Wireless Remote Controller
( CZ-RWSU2N, CZ-RWSD2, CZ-RWST3N, CZ-RWSL2N )
4. Setting the Current Time
11
(EN)
ENGLISH
After changing the batteries and pressing the Reset
button, be sure to reset the current time.
(When the Reset button is pressed, the current time
reverts to [
].)
1. Press for two seconds or more.
Once the clock displays starts blinking, the clock
can be set.
2. Set the hour with / of the .
If you press and hold the button, the time changes
quickly.
3. Set the minutes with / of the .
If you press and hold the button, the time changes
quickly.
4. Pressing completes the time setting.
• While you are setting the current time, the time
display ashes and the colon lights up.
• If the buttons are not pressed for three minutes
while setting the current time, it is set to the
displayed time.
Note
• When the Reset button is pressed, the timer settings are canceled.
2 1, 4
3
00OI303000.indb11 2015/02/2016:23:02
3. Installing Batteries
10
(EN)
1. Remove the cover.
2. Insert two LR03 size batteries.
Put the batteries in with the polarity [+/–]
as shown in the gure.
3. Gently insert one end of an
unfolded paper clip (or a similar
object that can t) into the Reset
hole and press the Reset button
inside the hole, then put the cover
back on.
Notes
• Change the batteries when the display of the
remote controller gets weak, or if it will not work
unless close to the receiver.
(Alkaline batteries generally last about one year.)
• When changing batteries, always use two fresh batteries of the same make.
• If the remote controller will not be used for a long period of time, remove the batteries.
• Please dispose of batteries appropriately.
• After changing the batteries, follow the procedures on the next page to reset the
current time.
How to Remove Batteries
1. Remove the cover.
2. Press the battery toward the
negative end and lift it out by
its positive end. (See the
gure on the right.)
3. Remove the other battery in
the same way.
Note
• Dispose of the used batteries at the designated location in compliance with the
applicable local ordinances.
Warning
• Do not swallow the battery.
•
After removing the battery from remote controller, keep it out of the reach of children.
The battery can cause death by suffocation if swallowed.
• When inserting the battery, make sure the polarities (+ and -) are correct.
Reset hole
Cover
00OI303000.indb10 2015/02/2016:23:02
SM830241-00_2WAY SYS.indb 32 2015/03/26 14:55:10
To Next Page
Loading...
Need help?
General
