Panasonic CZ-RTC4 - Specifications

Optional Controller
Manual of Controller
2 - 8
1. Timer Remote Controller (CZ-RTC4)
13
(EN)
Note
 After deleting, the unit returns to the program con rmation mode .  If you press [CANCEL] during the setting, the unit returns to the program
com rmation mode.
 If there is no operation made for 10 minutes during the setting, the unit returns to
the normal mode.
To delete the program timer setting, follow the steps below.
1
Press [PROGRAM] to enter the program con rmation mode.
A
41 5 2 / 3
2
Press [▼/▲] to select the day of the program you want to delete. Press [SET] to  x the day.
3
Press [▼/▲] to select a TIMER No. (from 1 to 6).
4
Press [SET] to display the program setting mode
.
5
Press [DELETE] to delete the program.
Weekly Program Function
Deleting the Program Timer
12
(EN)
4
Set the program pattern. (Program step 3) There are 4 program patterns. Pressing [▼/▲] repeats the following display patterns.
°°
Pattern 1 (Default display)
[▼] [▼]
Pattern 2
[▲] [▲]
Pattern 4
[▲][▲]
Pattern 3
[▼
][
▼]
The indoor unit starts operation at the programmed time.
The indoor unit starts operation at the programmed time and changes the temperature settings.
The indoor unit stops operation at the programmed time. The indoor unit changes the temperature setting at the programmed time.
For Pattern 3 and Pattern 4: Press [ / ] to change the temperature setting.
5
Select the program pattern and press [SET]. The program timer setting is con rmed and the unit enters the con rmation mode
.
Note
 If you press [CANCEL] during the setting, it returns to the program con rmation
mode.
 If there is no operation made for 10 minutes during the setting, it returns to the
normal mode. In this case, all the settings in progress will be invalid.
SM830241-00_2WAY SYS.indb 8 2015/03/26 14:54:53