Optional Controller
Manual of Controller
2 - 34
2. Wireless Remote Controller
( CZ-RWSU2N, CZ-RWSD2, CZ-RWST3N, CZ-RWSL2N )
ENGLISH
15
(EN)
Combining ON and OFF Timers
• The ON and OFF timers can be set respectively.
Checking the timer setting
• If you press either
/ for the or the , the scheduled time is
displayed for four seconds.
• When no timer setting has been made, it displays --:--. (Initial setting)
Changing a timer setting
• Press
/ for the or the , and then when the timer setting is
displayed, press
/ for the timer again.
Canceling a timer setting
• If you press [CANCEL], the timer setting is canceled.
• If you wish to cancel the setting for either the
or the timer,
press
/ , and long-press [CANCEL] while the scheduled time is
displayed.
Using the same timer setting every day
• If you press
for 2 or more seconds, “ ” is displayed and the ON
timer or the OFF timer will operate repeatedly every day.
• If you press
again for two seconds or more, “ ” goes off and the
timer operates only one time.
6. Timer Operation (Cont.)
00OI303000.indb15 2015/02/2016:23:05
6. Timer Operation
14
(EN)
• When setting the timer, make sure the current time on the remote controller
is accurate.
• The timer’s clock can only be set when the display of the remote controller
is ON.
• After setting the timer, put the remote controller for in a place where its
signal will reach the receiver of the indoor unit. (When the time set for the
timer is reached, a signal is sent from the remote controller to start or stop
the unit.)
Using the Timer
1. Press either
/ of the
or
, and
while the time is being displayed, if you
press
/ again, a scheduled time can
be set.
The time last set on the timer is displayed.
“--:--” indicates time to change the batteries.
2. Press either / of the
or
and
set the timer to the desired time.
Every time you press / , the time changes in
10 minute increments. If you press and hold the
button, the time changes quickly.
3. After setting the timer, if you press , the
time you set changes to a steady display,
indicating settings are complete.
After the timer setting is displayed for three seconds,
the display reverts to the current time.
1, 23
00OI303000.indb14 2015/02/2016:23:04
SM830241-00_2WAY SYS.indb 34 2015/03/26 14:55:11
To Next Page
Loading...
Need help?
General
